Filter
Top Products
Hardware Setup
2
1. Connect the power supply to the and to
AC power.The power (red) LED will light to indicate that the
unit is receiving power.
2. Connect to the Ethernet RJ-45 jack
of the .Attach the other end of the
crossover network cable to a host PC directly.
Network status is indicated by two LEDs on the RJ-45 connector.
The left (yellow) LED indicates network activity.It is on by default,
turning off when network activity occurs at the PayLink-IP.The right
(green) LED indicates a network link.It is off by default,but lights
when a network link exists.
LAVA PayLink-IP/Dial
an Ethernet cross-over cable
LAVA PayLink-IP/Dial
Power
connector
Power
indicator
Network
connector (RJ-45)
Network
Activity and Link
indicators