Filter
Top Products
37
Lenovo G560
Retaining serial numbers
This section presents the following descriptions:
• “Restoring the serial number of the system unit” on page 37
• “Retaining the UUID” on page 38
• “Reading or writing the ECA information ” on page 39
Restoring the serial number of the system unit
When the computer was manufactured, the EEPROM on the system board was
loaded with the serial numbers of the system and all major components. These
numbers need to remain the same throughout the life of the computer.
If you replace the system board, you must restore the serial number of the
system unit to its original value.
Before replacing the system board, save the original serial number by doing the
following:
1. Install the CE Utility Diskette for Lenovo notebooks, and restart the
computer.
2. From the main menu, select 1. Set System Identifi cation.
3. Select 2. Read S/N data from EEPROM.
The serial number of each device in your computer is displayed; the serial
number of the system unit is listed as follows:
20: Serial number•
Write down that number.
Note: The serial number of the system unit is also written on the label attached
to the bottom of the computer.
After you have replaced the system board, restore the serial number by doing
the following:
1. Install the CE Utility Diskette for Lenovo notebooks and restart the
computer.
2. From the main menu, select 1. Set System Identifi cation.
3. Select 1. Add S/N data from EEPROM.
Follow the instructions on the screen.
If the MTM and Product ID numbers differ from each other on the rear label,
apply what is shown for the Product ID fi eld. See the following example:
MTM on rear label:
TTTT-CTO S/N SSSSSSS
Product ID on rear label:
TTTT-MMM (apply this number when setting Serial Number)
In the example, the Serial Number to be applied is ‘1STTTTMMMSSSSSSS’.