Filter
Top Products
10. Position the new riser card assembly 2 on the chassis and align it with the riser card assembly 2 slot on
the system board and align the rear of it with the corresponding rail guides in the rear of the chassis.
Then, carefully press the new riser card assembly 2 straight down into the chassis until it is fully seated.
Note: If there is any PCI Express card installed on the riser card assembly 2, carefully t the PCI Express
card into the chassis and properly route any cables from the card.
Figure 106. Installing the riser card assembly 2
11. If you are instructed to return the old riser card assembly 2, follow all packaging instructions and use
any packaging materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 152.
Replacing the RAID card
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 69.
This topic provides instructions on how to replace the RAID card. If you are installing or removing any other
types of supported PCI Express cards, the procedure is similar.
Your server comes with a RAID card to provide advanced hardware RAID functions. For more information,
see “RAID card” on page 33 and “Conguring RAID” on page 64.
Attention: Ensure that you back up your data before replacing the RAID card because you might need to
recongure RAID and reinstall the operating system after replacing the RAID card.
Chapter 6. Installing, removing, or replacing hardware 139