Filter
Top Products
This section provides instructions on how to install the monitor stand.
Note: The monitor stand is available only in some models.
To install the monitor stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. If your computer is installed with a frame stand, press the release button toward the top of the computer
and lift the frame stand off the computer.
Figure 12. Removing the frame stand
4. To install the monitor stand, align the two clips on the top of the monitor stand with the two holes in
the chassis, and then press the release button toward the top of the computer until the monitor stand
is secured in position.
Chapter 5. Installing or replacing hardware 39