Lenovo 3292 Laptop User Manual


 
6. Open the retaining clips. If you are replacing an old memory module, open the retaining clips and
remove the memory module being replaced as shown.
Figure 16. Removing the memory module
7. Insert the notched end 2 of the new memory module into the slot 1 . Press the memory module
rmly and pivot the memory module until it snaps into place. Make sure that the memory module is
secured in the slot and does not move easily.
Figure 17. Installing a memory module
What to do next:
To work with another piece of hardware, go to the appropriate section.
To complete the installation or replacement, go to “Completing the parts replacement” on page 68.
Replacing the hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important
safety information” on page v.
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
Chapter 5. Installing or replacing hardware 41