Filter
Top Products
Figure 36. Installing the thermal sensor
9. Connect the thermal sensor cable to the system board. See “Locating parts on the system board”
on page 16.
10. Align the screw holes in the VESA mount bracket with those in the chassis and then install the screws to
secure the VESA mount bracket to the chassis.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 73
.
Replacing the integrated camera
Attention:
Do not open your computer or attempt any repair before reading and understanding “Important safety information”
on page v.
This section provides instructions on how to replace the integrated camera.
Note: The integrated camera is available only in some models.
To replace the integrated camera, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
Chapter 5. Installing or replacing hardware 59