Filter
Top Products
Figure 45. Removing the rear PS/2 connectors and serial port assembly
7. Align the screw hole in the new rear PS/2 connectors and serial port assembly with the corresponding
screw hole in the chassis. Then, install the screw to secure the new rear PS/2 connectors and serial
port assembly to the chassis.
8. Connect the cables of the new rear PS/2 connectors and serial port assembly to the system board. See
“Locating parts on the system board” on page 16.
9. Reinstall the rear I/O assembly. See “Removing and reinstalling the rear I/O assembly” on page 44.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 73.
Replacing the mouse
Attention:
Do not open your computer or attempt any repair before reading and understanding “Important safety information”
on page v.
This section provides instructions on how to replace the mouse.
• If you are using a wired mouse, do the following:
1. Disconnect the old mouse cable from the computer.
2. Connect a new mouse to the appropriate connector on the computer. Your mouse might be
connected to a PS/2 mouse connector 1 or a USB connector 2 . Depending on where to connect
your mouse, see “Locating connectors, controls, and indicators on the front of your computer” on
page 9
or “Locating connectors on the rear of your computer” on page 11.
Chapter 5. Installing or replacing hardware 69