Lenovo 3313 Laptop User Manual


 
7. Carefully release the Bluetooth module and lift the Bluetooth module out of the computer.
Figure 38. Removing the Bluetooth module
8. Position the new Bluetooth module into the computer front bezel and then press the new Bluetooth
module downward until it is secured into place.
9. Connect the new Bluetooth module cable to the system board. See “Locating parts on the system
board” on page 15.
10. Reinstall the rear I/O assembly. See “Removing and reinstalling the rear I/O assembly” on page 39.
What to do next:
To work with another piece of hardware, go to the appropriate section.
To complete the installation or replacement, go to “Completing the parts replacement” on page 68.
Replacing the card reader
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important
safety information” on page v.
This section provides instructions on how to replace the card reader.
Note: The card reader is available only in some models.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 36.
4. Locate the card reader. See “Locating components” on page 12.
5. Disconnect the card reader cable from the card reader.
6. Remove the two screws 1 that secure the card reader and then lift the card reader out of the computer.
Chapter 5. Installing or replacing hardware 59