Filter
Top Products
• DeviceID:
Contains the component's unit-ID that corresponds to a xed disk drive, removable media drive, serial or
parallel port, processor, specic RIMM, or a device on the PCI bus.
• Date:
Contains the date when the diagnostic test was run. The date is retrieved from CMOS and displayed
using the YYYYMMDD format.
• ChkDigits:
Contains a 2-digit check-digit value to ensure the following:
– Diagnostics were run on the specied date.
– Diagnostics were run on the specied computer.
– The diagnostic error code is recorded correctly.
• Text:
Description of the error.
Note: See “Diagnostic error codes” on page 46
for error code listings.
Quick and Full erase - hard disk drive
The diagnostics program offers two hard disk drive formatting utilities:
• Quick Erase Hard Drive
• Full Erase Hard Drive
Quick Erase Hard Drive provides a DOS utility that performs the following:
• Destroys the Master Boot Record (MBR) on the hard disk drive.
• Destroys all copies of the FAT Table on all partitions (both the master and backup).
• Destroys the partition table.
• Provides messages that warn the user that this is a non-recoverable process.
Full Erase Hard Drive provides a DOS utility that performs the following:
• Performs all the steps in Quick Erase.
• Provides a DOS utility that writes random data to all sectors of the hard disk drive.
• Provides an estimate of time to completion along with a visual representation of completion status.
• Provides messages that warn the user about a non-recoverable process.
Important: Make sure that all data is backed up before using the Quick or Full Erase functions.
To select the Quick Erase Hard Drive or Full Erase Hard Drive utility, do the following:
1. Select the UTILITY option on the toolbar and press Enter.
2. Select either the QUICK ERASE or FULL ERASE HARD DISK option and follow the instructions on
the screen.
Viewing the test log
Errors reported by the diagnostic test will be displayed by the program as a failed test.
To view details of a failure or to view a list of test results, use the following procedure from any test category
screen:
1. Press F3 to activate the log le.
36 Hardware Maintenance Manual