Filter
Top Products
Using the Serial ATA Hard Drive Bay Adapter III
This section provides information on installing a supported hard disk drive
into your Ultrabay media bay using the Serial ATA Hard Drive Bay Adapter
III.
Note:
The adapter supports only the 2.5-inch Serial ATA hard disk drive. It
does not support ThinkCentre
®
hard disk drives, Lenovo China hard disk
drives, or hard disk drives from other companies.
Handling a hard disk drive
To protect a hard disk drive during installation, observe the following
precautions:
v Keep the drive in its static-protective bag until you are ready to install the
drive in your ThinkPad computer. If you take the drive out of the
static-protective bag, place the static-protective bag on a flat, padded surface,
and then place the drive on the bag with the component side facing up.
v Handle the drive with care. Dropping or jarring the drive can damage the
components inside the drive housing.
v Limit your movement. Movement can cause static electricity buildup.
v Do not subject the drive to physical shocks.
v Handle the drive by the edges.
v Do not touch any exposed components on the drive.
v Do not apply pressure to the cover of the drive.
Attention: The hard disk drive is very sensitive. Incorrect handling can cause
damage and permanent loss of data on the drive.
© Copyright Lenovo 2009 2-1