Filter
Top Products
Chapter 1. 1-3
Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
Note: Be sure to read the Safety Information located in the
Monitor Safety,
Troubleshooting, and Warranty Guide
before carrying out this procedure.
1. Power off your computer and all attached devices, and unplug the computer
power cord.
Connect the analog signal cable to the video port on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
Cable lock slot
Your monitor is equipped with a cable lock slot located on the rear of your monitor (in
the lower position). Please see the instructions that come with the cable lock to learn
how to attach it.
2. Remove the Cable Cover from the back of the stand.
Place the cable into the specific hook indicated in below figure.
3.