Filter
Top Products
9. Slide the new optical drive into the drive bay until it snaps into position.
Figure 36. Installing a new optical drive
10. Connect the signal cable and the power cable to the rear of the optical drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 68.
Installing or replacing the card reader
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace the card reader.
Note: The card reader is only available in some models. For new installation, see “Installing the card reader”
on page 54. For replacement, see “Replacing the card reader” on page 57.
Installing the card reader
To install the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
54 ThinkCentre User Guide