Lenovo 4497 Computer Hardware User Manual


 
Locating internal drives
Internal drives are devices that your computer uses to read and store data. You can add drives to your
computer to increase storage capacity and enable your computer to read other types of media. Internal
drives are installed in bays. In this manual, the bays are referred to as bay 1, bay 2, and so on. Your
computer comes with the following factory-installed drives:
An optical drive in bay 1
A 3.5-inch hard disk drive in bay 3
When installing or replacing an internal drive, it is important to note the type and size of the drive that you
can install or replace in each bay and correctly connect the cables to the drive installed. Refer to the
appropriate section in “Installing or replacing hardware” on page 121
for instructions on how to install or
replace internal drives for your computer.
Figure 53 “Drive bay locations” on page 120
shows the locations of the drive bays.
Figure 53. Drive bay locations
1 Bay 1 - Optical drive bay (with an optical drive installed)
2 Bay 2 - Card reader drive bay
2 Bay 3 - SATA hard disk drive bay (with a 3.5-inch hard disk drive installed)
Handling static-sensitive devices
Do not open the static-protective package containing the new part until the defective part has been removed
from the computer and you are ready to install the new part. Static electricity, although harmless to you, can
seriously damage computer components and parts.
When you handle computer parts and components, take these precautions to avoid static-electricity damage:
Limit your movement. Movement can cause static electricity to build up around you.
120 ThinkCentre Hardware Maintenance Manual