Filter
Top Products
Replacing the front fan assembly
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the front fan assembly.
To replace the front fan assembly:
1. Remove the computer cover. See “Removing the computer cover” on page 14.
2. Remove the front bezel. See “Removing and installing the front bezel” on page
15.
3. Disconnect the front fan assembly cable from the power fan connector on the
system board. See “Locating parts on the system board” on page 11.
4. The front fan assembly is attached to the chassis by four rubber mounts.
Remove the front fan assembly by breaking or cutting the rubber mounts and
gently pulling the front fan assembly out of the chassis.
5. Install the new front fan assembly by aligning the new rubber mounts of the
new front fan assembly with the holes on the chassis and push the rubber
mounts through the holes.
Note:
The new front fan assembly you received will have four new rubber
mounts attached.
Figure 31. Removing the front fan assembly
Chapter 2. Installing options and replacing hardware 39