Filter
Top Products
5. Remove the memory module being replaced by opening the retaining clips as
shown.
6. Position the replacement memory module over the memory connector. Make
sure the notch 1on the memory module aligns correctly with the connector
key 2 on the system board. Push the memory module straight down into the
connector until the retaining clips close.
7. Reinstall the PCI riser assembly and adapters.
8. Go to “Completing the CRU replacement” on page 28.
Replacing an adapter
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Quick Reference that was included with your computer or in the
Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Quick
Reference or the HMM, go to the Support Web site at
http://www.lenovo.com/think/support.
To replace the adapter:
1. Open the computer cover. See “Opening the cover” on page 5.
Chapter 2. Replacing hardware 19