Filter
Top Products
Installing
a
drive
To
install
an
internal
drive,
follow
these
steps:
1.
Remove
the
cover.
See
“Removing
the
cover”
on
page
34.
2.
If
your
computer
has
a
CD
drive
or
DVD
drive,
you
might
need
to
remove
the
signal
and
power
cables
from
the
drive.
3.
Remove
the
bay
panel
from
the
drive
bay
by
inserting
a
flat-blade
screwdriver
at
the
end
and
gently
prying
it
loose.
4.
Remove
the
metal
shield
from
the
drive
bay
by
inserting
a
flat-blade
screwdriver
into
one
of
the
slots
and
gently
prying
it
loose.
5.
Make
sure
the
drive
that
you
are
installing
is
set
correctly
as
either
a
master
or
a
slave
device.
Note:
A
serial
ATA
hard
disk
drive
does
not
need
to
be
set
as
either
a
master
or
a
slave
device.
v
If
it
is
the
first
CD
drive
or
DVD
drive,
set
it
as
a
master
device.
v
If
it
is
an
additional
CD
drive
or
DVD
drive,
set
it
as
a
slave
device.
v
If
it
is
an
additional
parallel
ATA
hard
disk
drive,
set
it
as
a
slave
device.
Refer
to
the
documentation
that
comes
with
your
drive
for
master/slave
jumper
information.
Chapter
2.
Types
8126,
8174,
8175,
and
8176
41