Filter
Top Products
Setting up your monitor
This section provides information on how to set up your monitor.
Connecting and turning on your monitor
1. Power off your computer and all attached devices, and unplug the computer
power cord.
2. Connect the analog signal cable to the video port on the back of the computer.
Note: One end of the signal cable is already pre-attached to your monitor.
Place the cable into the specific hook indicated in below figure.
3. Connect the digital cable to the DVI connector of the monitor and the other end
on the back of the computer.
Place the cable into the specific hook indicated in below figure.
4. Insert the power cord into the monitor ,then plug the monitor power cord and the
computer cord into grounded electrical outlets.
Chapter 1. 1-4
1.
power cord.
Note: Be sure to read the Safety Information located in the Monitor Safety, Troubleshooting,
and Warranty Guide before carrying out this procedure.