Filter
Top Products
When installing: When you attach the palm rest, do as follows:
1. Attach the fingerprint reader connector firmly to the system board.
2. Attach the palm rest so that the two projections of the palm rest (a) firmly fit
into the guide holes of the keyboard bezel as shown in this figure.
a
a
3. Push the front side of the palm rest until it clicks into place.
4. Close the LCD cover and turn the computer over. Then fasten the four screws
to secure the palm rest.
Removing and replacing a FRU
ThinkPad R61, R61e, and R61i (15.4-inch widescreen) 63