Filter
Top Products
Installation
The setup of the Switch can be performed using
the following steps:
1. The surface must support at least 1.5 Kg for
the Switch.
2. The power outlet should be within 1.82
meters (6 feet) of the Switch.
3. Visually inspect the DC power jack and
make sure that it is fully secured to the
power adapter.
4. Make sure that there is proper heat
dissipation from and adequate ventilation
around the Switch. Do not place heavy
objects on the Switch.
Connecting Network Cable
The Switch supports 10Mbps Ethernet or
100Mbps Fast Ethernet and it runs both in half
and full duplex mode using two pair of Category
5 cable.
These RJ45 ports are Auto-MDI type port. The
Switch can auto transform to MDI-II or MDI-X
type, so you can just make an easy connection
that without worrying if you are using a standard
or crossover RJ45 cable.
10