Filter
Top Products
Desktop Installation
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is grease and
dust free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the Rubber Feet to each corner on the bottom of the Switch.
These footpads can prevent the Switch from shock/vibration.
Rack-mounted Installation
FSW-1621/2421 10/100Base-TX Switch comes with a long rack-mounted
kit and can be mounted in an EIA standard size, 19-inch Rack. The Switch
can be placed in a wiring closet with other equipment.
Perform the following steps to rack mount the switch:
A. Position one bracket to align with the holes on one side of the switch
and secure it with the smaller bracket screws. Then attach the
remaining bracket to the other side of the Switch.
B. After attached both mounting brackets, position FSW-1621/2421 in the
rack by lining up the holes in the brackets with the appropriate holes on
the rack. Secure the Switch to the rack with a screwdriver and the
rack-mounting screws.
Power On
Connect the power cord to the power socket on the rear panel of the
Switch. The other side of power cord connects to the power outlet. The
external power supply in the Switch works with AC in the voltage range
100-240VAC, frequency 50~60Hz.Check the power indicator on the front
panel to see if power is properly supplied.