Filter
Top Products
62
Function name:
VLAN Tag Priority
Function description:
In vlan tag, there are 3 bits belonging to priority. According to these 3 bits, we could
arrange 8 traffics –0 0 0, 0 0 1, 0 1 0, 0 1 1, 1 0 0, 1 0 1, 1 1 0, 1 1 1. We can set High
priority or Low priority for each traffic class. For instance, if we let VLAN-tagged priority
0 0 0 be high priority and VLAN-tagged priority 0 0 1 be Low Priority, and then make
port 1, 2, 3 be in the vlan 2. We sent the packets that have the value 0 0 0 in vlan-
tagged field and VID equals 2 from the port 2 and the packets that have the value 0 0 1
in vlan-tagged field and VID equals 2 from the port 3 into the switch. We let the two
kinds of packets be transmitted for port 1 until the port results in congestion. The result
is that the packets will be dropped partially from the port 3 because the packets that
belong to Low Priority. For the use of VLAN Tag Priority function, please press
<Configure> button at the right section for setting in advance.
Fig. 3-19
Parameter description:
Quality of Service (QoS) Vlan Tag Configuration:
Used for setting up the QoS belongs to Vlan operation.
Port:
User can set up the port (1~8) respectively to let Vlan Tag QoS function
work on them. If you would like to set up all ports at a time, user is also
allowed to choose “All” in the selection list to simplify the procedure of
configuration.
Bit 0, Bit 1, Bit 2:
According to the arrangement of VLAN-tagged priority, it can form 8
kinds of traffics, including 0 0 0, 0 0 1, 0 1 0, 0 1 1, 1 0 0, 1 0 1, 1 1 0
and 1 1 1.
Class:
8 kinds of traffic as mentioned above, user can set up High Priority or
Low Priority for each port respectively.