Filter
Top Products
25
Configuring the Switch
The 48+4G-Port 10/100/1000Mbps Gigabit Ethernet Web Smart
Switch has a Web GUI interface for smart switch configuration. The
Switch can be configured through the Web Browser. A network
administrator can manage, control and monitor the switch from the
local LAN. This section indicates how to configure the Switch to
enable its smart functions including:
Port Setting (Speed/Disable, Duplex mode, Flow Control and
Port base QoS)
Virtual LAN Group setting (VLAN)
Trunking
System Setting
Device status and Statistic
Login
Before you configure GSW-4870TGX, note that when the Web Smart
Switch is configured through an Ethernet connection, make sure the
manager PC must be set on same the IP network. For example, when
the default network address of the default IP address of the Web Smart
Switch is 192.168.0.1, then the manager PC should be set at
192.168.0.x (where x is a number between 2 and 254), and the default
subnet mask is 255.255.255.0.