Filter
Top Products
Remove the sticker and tape
from the print cartridges.
8
1
2
1
2
1
2
3
Unpack your All-In-One.
Note: Contents may vary based on geography.
1
Note: You may need to purchase a USB
cable separately.
www.lexmark.co
m
3300 Series All-In-One
Connect the power cord to the power supply.
2
2
1
Lift the paper support and extend
the paper exit tray.
5
6
2
1
3
See the troubleshooting guide on the reverse of this sheet.
Make sure the power light is on.
3
Lift the scanner unit.
7
Close the scanner unit.
10
1
2
3
Your All-In-One may include a
photo cartridge instead of a
black print cartridge.
Before you continue, remove the
photo cartridge from the print
cartridge storage unit.
Note: Save the print cartridge
storage unit to protect any open
cartridges not in use.
Press to scroll to your language
and then press .
4
1 Pull back the transparent deflector.
2 Load the paper flat and to the right.
3 Squeeze the paper guide. Slide it
to the right until it is snug.
1 Open the cartridge lids by pressing the front tabs.
2 Insert the cartridges and push them down firmly.
3 Snap the lids tight.
9
Press to print
an alignment page.
You may discard the page
after it prints.
11
Left:
photo
or
black
Right:
color
only
Steps 12–15
Safety information
CAUTION: Do not set up this product or make any electrical or cabling connections, such as the power supply cord or
telephone, during a lightning storm.
• Use only the power supply provided with this product or the manufacturer's authorized replacement power supply.
• Connect the power supply cord to an electrical outlet that is near the product and easily accessible.
• Refer service or repairs, other than those described in the user documentation, to a professional service person.
*23A0170*