Filter
Top Products
56 Standard parallel port disabled
Try one or more of the following:
• The printer discards any data received through the parallel port. Press to clear the message and continue
printing.
• Make sure the Parallel Buffer menu item is not set to Disabled.
58 Too many flash options installed
Try one or more of the following:
• Turn the printer off, and then remove extra flash options:
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess flash memory.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
• Press to clear the message and continue printing.
58 Too many trays attached
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
Note: Optional trays lock together when stacked. Remove stacked trays one at a time from the top down.
3 Remove the additional tray(s).
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
59 Incompatible tray <x>
Only options designed specifically for this printer are supported.
Try one or more of the following:
• Remove the specified tray.
• Press the arrow buttons until Continue appears, and then press to clear the message and continue printing
without using the specified tray.
84 PC Kit life warning
The photoconductor kit is near exhaustion.
Try one or more of the following:
• Press to clear the message and continue printing.
• Order a replacement photoconductor kit immediately. When print quality is reduced, install the new
photoconductor kit.
Troubleshooting
109