Filter
Top Products
106
Method 1 -- TCP/IP
1
Assign an IP address to the print server.
– If you are running DHCP, your IP address is automatically assigned. Push the test button
on MarkNet print server to print a network setup page. You can find the address under the
TCP/IP heading.
– If you are not running DHCP, you can manually assign an IP address using the printer
operator panel (see
SET THE IP ADDRESS USING THE PRINTER OPERATOR PANEL).
2 Type the IP address in the address bar of your browser (for example,
http://156.192.225.86).
3 When you reach the MarkNet web pages, click Configuration/AppleTalk/Advanced Settings.
4 In the top section, make the following changes:
– Change Type to Hb PCL emulation. (The default is LaserWriter. LaserWriter will not
work correctly with your J110 printer.)
– Delete the Prefix and PostScript strings
– Change Mode to RAW
5 Click Submit to save your changes.
Method 2 -- Universal configuration files (UCF)
Two universal configuration files (UCF) are shipped on the Drivers, MarkVision and Utilities CD. They
are installed on your computer in a Lexmark Extras folder when you set up your printer. You can use
MarkVision or ftp the files to the MarkNet print server.
Set the AppleTalk type
You can use MarkVision to send the SetApple.ucf universal configuration file to the MarkNet print
server to change the AppleTalk type from LaserWriter to
Hb PCL emulation.
If you use ftp to send the file, use the following address structure: IP Address/Dev/Config (for example,
//1157.184.12.30/Dev/Config).
Reset the default
The ResetApple.ucf universal configuration file resets the AppleTalk type back to the default
(LaserWriter).
Additional configuration
The following instructions include setting IP address information, creating a Desktop printer, installing
MarkVision, and how to change the AppleTalk zone for your printer.