Lexmark T632 Printer User Manual


 
111
Solving printing problems
Job did not print or incorrect
characters printed
(continued).
If you are using a print spooler, verify that the spooler is not stalled.
If you print across a network or on a Macintosh computer, see
Solving network printing problems.
Check the printer interface from the Setup Menu.
Determine which host interface you are using. Print a menu settings
page to verify that the current interface settings are correct. See
Solving network printing problems.
If you are using a serial interface:
Make sure Honor DSR is set to Off.
Check the protocol, baud, parity, and data bit settings. The settings
on the printer and on the host computer should match.
Printer is connected to the
USB port, but will not print.
Make sure you are using Windows 98, Windows 2000, Windows Me,
or another USB-capable operating system supported by Lexmark.
Print media misfeeds or
multiple feeds occur.
Make sure the print media you are using meets the specifications for
your printer. See Identifying print media sources and
specifications for more details.
Flex print media before loading it in any of the sources.
Make sure the print media is loaded correctly.
Make sure the width and length guides on the print media sources are
adjusted correctly.
Do not overfill the print media sources.
Do not force print media into the multipurpose feeder when you load
it; otherwise, it may skew or buckle.
Remove any curled print media from sources.
Load the recommended print side correctly for the type of print media
you are using. See Loading print media in standard and optional
trays for more information.
Load less print media in the sources.
Turn the print media over or around and try printing again to see if
feeding improves.
Do not mix print media types.
Do not mix reams of print media.
Remove the top and bottom sheets of a ream before loading the print
media.
Load a print media source only when it is empty.
Envelope misfeeds or
multiple feeds occur.
Remove the stack of envelopes from the envelope feeder. Load one
envelope, feed it through the printer, and then reload the stack of
envelopes in the envelope feeder.
Page breaks in unexpected
places.
Check the Print Timeout setting in the Setup Menu. Increase the
setting.
Problem Action