Filter
Top Products
74
Using and loading the optional 2000-sheet drawer
Changing the print media size for the 2000-sheet drawer
Your 2000-sheet drawer comes pre-configured for either letter or A4 size.
To change the print media size prior to installation, proceed to step 7 of the following instructions
now. If you are changing the print media size for a unit that is already attached to a printer and a
power source, proceed with step 1:
1 Open the loading door.
2 Push the elevator button located on the left side of the door opening. See the illustration on
page 72.
3 Remove paper from the elevator tray and close the loading door.
4 Re-open the door. The printer elevator tray should be approximately halfway up.
5 Unplug the power cord.
6 Remove the printer and all attached options from the 2000-sheet drawer.
CAUTION: Remove the attached options one at a time. Make sure your fingers are not under
the printer when you set it down. Use the handholds on the printer or ask someone
to help you lift it.
7 Locate the size selector knob on top of the drawer. See page 75 for an illustration and
location of the knob.
Note: Six paper selections are available. Each paper selection is color-coded. A new print
media size is displayed on the operator panel after the paper elevator tray is in the
up position.
8 To make a selection, turn the knob completely in a counterclockwise direction. This action
sets the print media size to legal (LGL).