Filter
Top Products
Replacing the photoconductor
1 Press the access button on the left side of the
MFP, and open the front cover.
2 Pull on the handle to remove the print cartridge
assembly.
3 Place the print cartridge assembly on a flat,
clean surface.
4 To remove the toner cartridge:
a Press the button on the print cartridge
assembly.
b Remove the toner cartridge using the
handle.
5 Unpack the photoconductor kit.
6 Install the toner cartridge into the new
photoconductor.
Note: The toner cartridge snaps into place
when correctly installed.
7 Reinstall the print cartridge assembly.
8 Press and hold Stop for three seconds to reset
photoconductor recount.
9 Close the front cover.
Cleaning the scanner glass
1 Slightly dampen a soft, lint–free cloth or paper
towel with water.
2 Open the top cover.
3 Wipe the surfaces of the scanner glass and
ADF until they are clean and dry.
4 Wipe the underside of the white top cover and
white sheet until it is clean and dry.
5 Close the top cover.
Cleaning the outside of the MFP
Wipe the outside surface of the MFP with a soft,
clean, lint–free cloth. If you dampen the cloth slightly
with water, be careful not to let any water drip onto or
inside the MFP.
Cleaning the inside of the MFP
CAUTION: The fuser area is hot. Avoid contact
with the fuser area to prevent burns.
Warning: While cleaning the inside of the
MFP, be careful not to touch the
transfer roller located under the
toner cartridge. Oil from your fingers
can affect print quality.
1 Turn the MFP off, unplug the power cord, and
then wait for the MFP to cool down.
2 Open the front cover, and pull on the handle to
remove the print cartridge assembly.
Warning: Do not touch the green
photoconductor drum.
3 Place the print cartridge assembly on a clean,
dry surface.
4 With a dry, lint–free cloth, wipe away any dust
and spilled toner from the print cartridge area.
5 Reinsert the print cartridge assembly, and close
the front cover.
6 Plug in the power cord and turn the MFP on.
1
2