LG Electronics 47WV30BR Printer User Manual


 
27
ENG
ENGLISH
MULTIVISION CONFIGURATION
Setting the Picture ID
Picture ID is used to change the settings of a
specific set (display) using a single IR receiver for
multi-vision. The set receiving the IR signal com-
municates with another set via the RS232 connec-
tor. Each set is identified by a Set ID. If you as-
sign the Picture ID using the remote control, only
displays with the same Picture ID and Set ID can
be controlled remotely.
1 Press the ID On (Red) button on the remote con-
trol.
2 If you press the left/right buttons or press the
ON button repeatedly, the Picture ID cycles
through OFF and 1 to 4.Assign the ID you
want.
If you assign the Set ID to each set with
multi-vision, and then assign the Picture ID
using the red button on the remote control,
the key command is displayed for the set
with the same Set ID and Picture ID.
A set
with different Set IDs and Picture IDs cannot
be controlled by IR signals.
Refer to the Set ID on page 46 for assigning
a Set ID.
The maximum value of the Picture ID can be
set in the Total Set ID menu.
Please refer to the Installation Manual for
more information on the assignment of a
Total Set ID.
ID
BACK
TILE
ON
OFF
EXIT
For example, if the Picture ID is assigned
to 2, the upper right display (Set ID: 2) can
be controlled by IR signals.
For each set, you can change the settings
for the PICTURE, AUDIO, TIME, OPTION,
NETWORK and MY MEDIA menus or the
hot keys on the remote control.
If you press the ID OFF (Green) button,
the Picture IDs for all sets are turned off. If
you then press any button on the remote
control, all sets will start working again.
The Picture ID function may not work dur-
ing MY MEDIA operating.
NOTE
Picture ID
Close
Off
2X2 Multi-Vision (Total Set ID: 4)
Set IDs are assigned as shown in the picture.
IR Receiver
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
Picture ID
Close
Off