Filter
Top Products
Connecting the Display
A3
Important
This illustration depicts the general model of connection. Your monitor may differ from
the items shown in the picture.
Once you connect the stand base, try not to disconnect it.
Do not carry the monitor upside down holding only the stand base. The monitor may
fall and get damaged or injure your foot.
Before setting up the monitor, ensure that the power to the monitor, the computer
system, and other attached devices is turned off.
Attaching/Separating the stand base
1. Place the monitor with its front facing downward on a soft cloth.
2. Make sure the stand base directs to the correct direction(Front, Rear) and turn the
locking device at the bottom to OPEN to assemble the unit. After assembling the unit, turn
the locking device to LOCK before use.
Turn the locking device to OPEN to separate the stand base.
3
.
Once assembled take the monitor up carefully and face the front side
4
.
After connecting the cable, adjust the angle of the panel for easy use.
(To connect the cable, see page A5 for reference.)
Tilt Range : -5˚~20˚
Warning:
Do not put your hand (finger)
between head section and stand section when
adjusting angle of screen.
Your hand (finger) may get caught or wounded.
Ergonomic
It is recommended that in order to maintain
an ergonomic and comfortable viewing
position, the forward tilt angle of the monitor
should not exceed 5 degrees.
Stand Body
Stand Base
LOCK
OPEN
Head section
Stand section