Filter
Top Products
8
ENG
ENGLISH
NETWORK MONITOR CONFIGURATION
1
The MultiPoint Manager will run automatically upon booting the operating system.
2
On the first boot after the installation of the operating system, MultiPoint Manager will start in mainte-
nance mode.
3
Add user accounts for multi-user.
4
Adjust the screen resolution for each station accordingly.
5
If you switch to normal mode, the multi-computing environment will be established after the reboot.
MultiPoint Manager
Using MultiPoint Manager
y
MultiPoint Manager runs automatically when the PC boots up; run time may vary depending on the
system.
y
When adjusting the window size of MultiPoint Manager on a PC with Display Link installed, the user
interface tab area may not be fully visible.
y
If you disconnect then re-connect the USB cable of the standard station, the user account of the cor-
responding station may be displayed in duplicate in MultiPoint Manager for several seconds.
y
WMS 2011 can enable automatic logon for each individual station. If you delete a user account with
automatic logon, the corresponding station will switch to manual logon mode.
y
Also, blocking a screen during full-screen playback will cancel the full-screen mode.
y
The MultiPoint Manager projection function may not work properly when playing a video in full screen.
y
If the mode-changing function of MultiPoint Manager freezes, reboot your PC.
y
MultiPoint Manager occasionally fails to display currently connected user accounts. This is not related
to the monitor's performance.
NOTE