Filter
Top Products
8
INSTALLATION
This UPS is designed for data processing equipment. Maximum load
must not exceed that shown on the UPS rating label. Do not connect
equipment that could overload the UPS or draw half-wave current
from the UPS, for example: electric drills, vacuum cleaners, laser
printers or hair dryers. Your total load earth leakage current must not
exceed 3.5 mA. Most data processing equipment meets this require-
ment if you use no more than two pieces of equipment. If uncertain
about your load, consult your local dealer, Liebert representative, or
Liebert Worldwide Support Group.
1. Visually inspect the UPS for freight damage. Report damage to the
carrier and your local dealer, Liebert representative or the Liebert
Worldwide Support Group.
2. Decide where to place the PowerSure PST. Install the UPS indoors
in a controlled environment, where it cannot be accidentally turned
off. Place it in an area of unrestricted airflow around the unit, away
from water, flammable liquids, gases, corrosives, and conductive
contaminants. Maintain an ambient temperature range of 32°F to
104°F (0°C to 40°C).
3. Plug the PowerSure PST’s attached 6.5-ft. (2m) power cord into an
AC outlet. Check that the Site Wiring Fault Indicator is not illumi-
nated. If it is lit, refer to the Troubleshooting section.
4. Plug any computers and monitors into the orange battery backed up
receptacles.
NOTE
UPS operation in temperatures above 77°F (25°C) reduces
battery life.
Inkjet
Printer
Scanner FAX
Machine
Plug computers, monitors & network hubs
into orange receptacles.
Plug this type of equipment into black
receptacles ONLY.