Lindy 42904 Switch User Manual


 
English Manual
2
1. Introduction
The LINDY USB 2.0 AutoSwitch makes it possible to share USB devices between several USB
computers. The AutoSwitch is designed to operate with computers, which have a USB 2.0 or
USB 1.1 interface. The USB 2.0 AutoSwitch also has the advantage of being backwards
compatible with USB 1.1 devices.
You may connect USB 2.0 or 1.1 devices directly to the USB 2.0 AutoSwitch; the connection of
a suitable USB hub will allow you to increase the number of connected devices. Please note
that only one computer may access the connected USB devices at any time!
Switching between the computers takes place by depressing the push button on the AutoSwitch
or by PS/2 keyboard hotkey (see operation paragrapth).
Note that during an active data transfer the attached computer must not be changed by
depressing the push button or hotkey!
Failure to do so may cause the loss of data!
2. Features
2 or up to 4 USB computers may share attached USB devices
Compatible with USB computers: PC, MAC, SUN
Compatible with USB 2.0 (EHCI) and USB 1.1 (OHCI, UHCI) specifications
Compatible with USB 1.1 and 2.0 devices, such as USB hard disk, USB printer, USB
scanner, USB W-LAN adaptor, USB IrDA adaptor, USB card reader and many more.
Powered via USB bus: External power supply not required
Switching via push buttom or PS/2 keyboard hotkey
Max. Cable length: Input and output: 2m
3. Contents
LINDY USB 2.0 AutoSwitch
This manual
4. Installation
Switch OFF all computers and USB devices to be connected. Connect the computers and USB
devices with suitable cables. The computers connect to the USB type B sockets found on the
AutoSwitch. Please note that cheap USB cables similar to those found on USB mice are not
suitable for use with the AutoSwitch. Poor quality cables may cause transfer problems and
eventually lead to the loss of data!
If you intend to connect any high-speed USB 2.0 devices, then it is important that you use high
quality USB 2.0 cables. Poor quality cables can usually be recognized by their smaller cable
diameter compared with high quality USB 2.0 cables. The maximum cable length at each input
and output must not exceed 2m.