Linksys WAP200E Network Router User Manual


 
PRODUCT DATA
BUSINESS SERIES
Features
Lightning protected, •
weather-resistant housing
10Base-T/100Base-TX •
Ethernet port, autosensing
half/full duplex and
MDI/MDI-X
Built-in 6-dBi directional •
antenna with 1x2 MIMO to
increase coverage
Obtains power via 802.3af •
Power over Ethernet (PoE)
from a PoE switch or power
injector
Simplified Web interface •
for installation and
configuration
Security Features: 802.1X/•
RADIUS Authentication
Supports WEP, WPA-PSK, •
WPA2-PSK, WPA-ENT,
WPA2-ENT wireless security
Supports 4 BSSID and •
802.1Q VLAN to SSID
mapping
Supports SNMP and intuitive •
Web-based interface
WMM wireless QoS support•
Supports wireless roaming •
based on 802.11F (IAPP)
Supports AP, Bridge Mode •
and Repeater mode
Supports wireless security •
monitoring (working
together with 200 series
client cards)
Supports wireless client •
isolation
3 Year limited warranty•
Wireless-G Exterior Access Point
with Power over Ethernet
Specifications
Model WAP200E
Standards IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u,
IEEE802.3af (Power over Ethernet), 802.1p (QoS priority), 802.1Q (VLAN),
802.1X (Security Authentication), 802.11i - Ready (Security WPA2),
802.11e - Ready (WMM & U-APSD), 802.11F (Wireless Roaming)
Ports 1 Ethernet, 1 External Antenna
Buttons Reset
Cabling Type UTP CAT 5
LEDs Power, Ethernet, Wireless
Operating System Linux
Setup/Config
Web UI Built-In Web UI for Easy Browser-Based Configuration (HTTP/HTTPS)
Static IP Yes
DHCP Client Yes
Management
SNMP Version 1, 2 and 2c
Event Logging Yes
Web F/W Upgrade Yes
Diags: Flash, etc. Flash, RAM, LAN, WLAN
Operating Modes
Access Point Access Point Mode, Point-to-Point Bridge Mode,
Point-to-Multipoint Bridge Mode, Repeater Mode
Wireless
Spec/Modulation 802.11b/DSSS, 802.11g/ODFM
Data Rates 802.11b: 1, 2, 5.5, 11 Mbps; 802.11g: 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps
Channels 11 North America, 13 Europe (ETSI and Japan)
Auto-Channel Selection
Number of Internal Antennas 2 x 6 dBi (directional)
Antenna Connector Type Reverse Polarity Female N-Type
Detachable Antenna Yes (sold separately)
RF Power (EIRP) in dBm 802.11g: Typical – 16.5 dBm, 802.11b: Typical – 17 dBm
Antenna Gain in dBi Internal Antenna: 6 dBi
Adjustable Power Yes
Receiver Sensitivity 802.11g: 54 Mbps@ -65 dBm, 802.11b: 11 Mbps@ -85 dBM
Security
WEP/WPA/WPA2 WEP, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT
Connection Control Wireless Connection Control: MAC-Based
SSID Broadcast SSID Broadcast Enable/Disable
802.1X IEEE 802.1X Support
Wireless Client Isolation Wireless Client Devices Can Be Isolated from Each Other Either
Within an SSID or Between Two SSIDs. However, Both Isolation Modes Can
Be Enabled at the Same Time.
Web-Based Utility
Access Control HTTP/HTTPS, Wireless Client Web GUI Access Control
Wireless Security
WEP Bits 64, 128
WPA Bits and Params. 128 - TKIP/AES
WPA2 Bits and Params. 256 - AES
SSID Broadcast On/Off Yes