Filter
Top Products
• Passphrase. This is the code used when logging a wireless device onto
the wireless network. It is a text string with a maximum of 16 alphanu-
meric characters. The WEP Key Settings are based upon the Passphrase
determined by you. Type that here. This passphrase may not work with
non-Linksys products due to possible incompatibility with other vendors’
passphrase generators.
8. The following Security Settings screen, shown in Figure 5-7, will allow you
to enter your WEP key. Each point in your wireless network must use the
same WEP key for the network to function properly. Verify that the appro-
priate key is entered and click the Next button to continue or Back to pre-
vious page.
12
Instant Wireless
TM
Series
Wireless Network Access Point
9. The next screen (Figure 5-8) will allow you to review your settings. If these
settings are correct, click the Ye s button to save these settings. If there are
any problems with the settings, click the No button and you will return to
the screen shown in Figure 5-2.
10. At this point, the configuration performed with the Setup Wizard is com-
plete, as shown in Figure 5-9. To configure any other Access Points in your
network, you can run this Setup Wizard again. Click the Exit button to exit
the Setup Wizard.
13
Figure 5-9
Figure 5-7
Figure 5-8