Filter
Top Products
45
Chapter 5: Setting Up and Configuring the Router
VPN Tab - Gateway to Gateway
10/100/1000 4-Port VPN Router
Advanced
For most users, the settings on the VPN page should be satisfactory. This device provides an advanced IPSec
setting page for some special users such as reviewers. Click the Advanced button to link you to that page.
Advanced settings are only for IKE with Preshared Key mode of IPSec.
Aggressive Mode: There are two types of Phase 1 exchanges: Main mode and Aggressive mode.
Aggressive Mode requires half of the main mode messages to be exchanged in Phase 1 of the SA exchange. If
network security is preferred, select Main mode. When users select the Dynamic IP in Remote Security Gateway
Type, it will be limited as Aggressive Mode.
Compress (Support IP Payload compression Protocol (IP Comp): The Router supports IP Payload
Compression Protocol. IP Payload Compression is a protocol to reduce the size of IP datagrams. If Compress is
enabled, the Router will propose compression when initiating a connection. If the responders reject this propose,
the Router will not implement the compression. When the Router works as a responder, the Router will always
accept compression even without enabling compression.
Keep-Alive: This mechanism helps to keep up the connection of IPSec tunnels. Whenever a connection is
dropped and detected, it will be re-established immediately.
AH Hash Algorithm: AH (Authentication Header) protocol describe the packet format and the default standards
for packet structure. With the use of AH as the security protocol, protected is extended forward into IP header to
verify the integrity of the entire packet by use of portions of the original IP header in the hashing process. There
are two algorithms, MD5 and SHA1. MD5 produces a 128-bit digest to authenticate packet data and SHA1
produces a 160-bit digest to authenticate packet data. Both sides of the tunnel should use the same algorithm.
NetBIOS broadcast: Check the box to enable NetBIOS traffic to pass through the VPN tunnel. By default, RV0041
blocks these broadcasts.
Click the Save Settings button when you finish the settings or click the Cancel Changes button to undo the
changes.
Figure 5-42: VPN tab - Gateway to Gateway
Advanced