Filter
Top Products
5
To connect network devices to the Switch, follow these instructions.
1. Make sure all the devices you will connect to the Switch are powered off.
2. Connect a Category 5 Ethernet
network cable to one of the
numbered ports on the Switch.
3. Connect the other end to a PC or other network device.
4. Repeat steps 2 and 3 to connect additional devices.
5. Connect the supplied power
adapter to the power port on
the Switch’s side panel.
6. Plug the other end of the adapter into an electrical outlet.
7. Power on the devices connected to the Switch. Each active port’s corre-
sponding LED will light up on the Switch.
Proceed to the following section, “Placement Options.”
Figure 3-3
Chapter 3: Connecting the
10/100/1000 Gigabit Switch
This chapter will explain how to connect network devices to the Switch. For an
example of a typical network configuration, see the application diagram shown
in Figure 3-1.
When you connect your network devices, make sure you don’t exceed the max-
imum cabling distances, which are listed in the following table:
Maximum Cabling Distances
*A hub refers to any type of 100Mbps hub, including regular hubs and stackable hubs. A 10Mbps hub
connected to another 10Mbps hub can span up to 100 meters (328 feet).
4
From
Switch
Hub
Switch or Hub
Switch or Hub*
Hub
Computer
Maximum Distance
100 meters (328 feet)
1
5 meters (16.4 feet) 1
100 meters (328 feet) 1
To
Overview
Connecting Network Devices
Figure 3-1
Note: Make sure you use the power adapter included with the Switch.
Using a different power adapter may result in damage to the Switch.
Figure 3-2
Note: Use Category 5e Ethernet network cables for your Gigabit con-
nections.