Filter
Top Products
7
Chapter 2
Connection
7
Power Over Ethernet Adapter Kit
NOTE: If the plug of the Splitter’s Power cord does not fit
into your network device, then use the included barrel jack
adapter. Plug the Splitter’s Power cord into the jack end, and
plug the other end of the barrel jack adapter into the Power
port of your network device.
Connect the Kit’s power adapter to the Injector, and plug the other
end into an electrical outlet or surge protector.
Congratulations! The installation of the Power Over Ethernet Kit is
complete.
Power on a Device that Uses Inline Power
Use only the Injector to power up a device that supports inline power.
Follow these instructions:
Connect the Injector’s built-in Ethernet network cable to your router,
switch, or other network device.
Connect the Kit’s included Ethernet network cable to the Injector’s
Power & Data OUT port.
6.
1.
2.