Filter
Top Products
Chapter 2
Configuration
5
12 Volt Power Over Ethernet Adapter Kit
Power on a Device that Uses Inline Power
Use only the Injector to power up a device that supports
inline power. Follow these instructions:
Connect the Injector’s built-in Ethernet network cable 1.
to your router, switch, or other network device.
Connect the Kit’s included Ethernet network cable to 2.
the Injector’s Power & Data OUT port.
Then connect the other end to the Ethernet port of 3.
your remotely located access point or other network
device.
NOTE: If the plug of the Splitter’s Power cord
does not fit into your network device, then
use the included barrel jack adapter. Plug the
Splitter’s Power cord into the jack end, and plug
the other end of the barrel jack adapter into the
Power port of your network device.
Connect the Kit’s power adapter to the Injector, and 4.
plug the other end into an electrical outlet or surge
protector.
Congratulations! The installation of the Power Over
Ethernet Kit is complete.