Filter
Top Products
Danish Interpretation Systems User Manual
Manual 01 18 04445
8
Front plate controls
Incoming Section
• Volume
This control adjusts the listening level in the
connected headphone
• Bass
This control adjust the Bass level in the connected
headphone
• Treble
This control adjust the Treble level in the connected
headphone
• a-b-c-d
These button selects between four pre-selection of
relay channels
• Relay-select
These buttons are used for each of the four pre-
selection to scroll through the available languages
• Floor
This button selects the floor language as the
listening language
Outgoing Section
• Microphone
This button switches on the microphone. When
switched ON, the button and the light ring on the
gooseneck microphone will light red.
• Mute
This button is used to temporarily switching off the
microphone (when coughing etc). The channel is
still “occupied” when pressing the button, but the
microphone is disconnected as long as the button is
depressed. Mute is indicated by switching off the
light in the light ring of the microphone.
• A
Press this button to select the A-language as the
outgoing channel. A Red LED is indicating, that A-
language is selected. The Yellow engaged LED is
indicating, that the A-channel is occupied i.e. a
microphone on an interpreter set is switched on at
this channel
• B
Press this button to select the B-language as the
outgoing channel. A Red LED is indicating, that B-
language is selected The Yellow engaged LED is
indicating, that the B-channel is occupied i.e. a
microphone on an interpreter set is switched on at
this channel.
• B-Select
After pressing the B-button, the B-language can be
selected (if ALL is chosen at the B-mode selection
in the B-language set-up menu.
• Speaking too fast
Pressing this button sends a signal to the Chairman,
that the Speaker has to slow down his speech.
• Call
Not implemented
Connectors
• XLR connector
The XLR-connector on the front is used for
connecting a microphone to the unit. Please note
that only DIS series GM40xx and GM44xx can be
used.
• Headphone connector
On each side of the interpreter set a mini jack is
located for connecting a headphone for listening to
the Floor language or one of the pre-selected relay
languages (a-b-c-d). On the left side a standard jack
connector is also located with the same
functionality.