Filter
Top Products
3-12 BIOS Configuration Utility
Copyright © 2004 by LSI Logic Corporation. All rights reserved.
Note that the logical drive should be at a RAID 1 level to start check
consistency. If you select a RAID 0 logical drive, a message displays
stating that a check consistency cannot be performed. To de-select a
logical drive, press the space bar again.
Step 3. Press <F10>.
Step 4. At the prompt, select Yes to start check consistency and press
<Enter>.
If you press <Esc> while the check consistency is in progress, the
following options display:
◊ Stop: The CU stores the percentage of the check consistency
already completed. When you restart the check consistency, it
continues from the last percentage completed rather than from zero
percent.
◊ Continue: Check consistency continues normally.
◊ Abort: The check consistency is completely aborted. If you restart
check consistency, it begins at zero percent.
3.8 Using a Pre-loaded System Drive
You can use the controller as an adapter for this drive by performing the
following steps:
Step 1. Connect the drive to the port on the controller.
Step 2. Boot the computer.
Step 3. Start the CU.
Step 4. Select Configure→ Easy Configuration from the menu.
Step 5. Press the cursor keys to select the pre-loaded drive.
Step 6. Press the spacebar.
The pre-loaded drive now becomes an array element.
Step 7. Press <Enter>. The pre-loaded drive is a one-disk array.
Step 8. Display the logical drive configuration screen.
Step 9. Highlight Accept and press <Enter>.
Step 10. Press <Esc> and select Yes at the prompt to save the configuration.