Filter
Top Products
MegaRAID SCSI 320-1 Hardware Guide 7-1
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Chapter 7
Troubleshooting
This chapter provides troubleshooting information for the MegaRAID
SCSI 320-1 controller. It contains the following sections:
· Section 7.1, “General Troubleshooting”
· Section 7.2, “BIOS Boot Error Messages”
· Section 7.3, “Other BIOS Error Messages”
· Section 7.4, “Other Potential Problems”
7.1 General Troubleshooting
Table 7.1 lists the general problems that can occur, along with suggested
solutions.
Table 7.1 General Problems and Suggested Solutions
Problem Suggested Solution
Some operating systems do not load in
a computer with a MegaRAID SCSI
320-1 controller.
Check the system BIOS configuration for PCI interrupt
assignments. Make sure some Interrupts are assigned for
PCI.
Initialize the logical drive before installing the operating
system.
One of the hard drives in the array fails
often.
Check the drive error counts using Power Console Plus.
(See the MegaRAID Configuration Software Guide for more
information.)
Format the drive.
Rebuild the drive
If the drive continues to fail, replace it with another drive with
the same capacity.