Filter
Top Products
Installing your Ultra320 SCSI Host Adapter 2-3
Version 2.1 Copyright © 2002-2003 by LSI Logic Corporation. All rights reserved.
2.1.2 Inserting the Host Adapter
Perform the following steps to install your Ultra320 SCSI host adapter in
the PC mainboard.
Step 1. Remove the blank bracket panel on the back of the computer
that is aligned with the PCI-X slot you have selected.
Save the bracket screw.
Step 2. Carefully insert the edge connector J1 of the host adapter into
the PCI-X slot, as shown in Figure 2.2.
Figure 2.2 Inserting the Host Adapter
Step 3. Make sure the edge connector is properly aligned before
pressing the adapter into place. The bracket around connectors
J2 and J3 should fit into the empty space where the blank
bracket panel was removed.
Bracket Screw
32-Bit Slots
64-Bit Slots