Filter
Top Products
Chapter 2 Installation
Cajun P118 Installation Guide 11
Rack Mounting
Cajun P110 switches slot into a standard 19 inch rack.
Remove the rubber legs from the base of any switch that is to be rack mounted.
Place the switches in the rack, and then connect the Exoplane, as follows:
1.
Snap open the ends of the front panel to reveal the fixing holes.
2.
Slot the switch into the rack. Insert the switches into the rack so that the switches
in a logical stack lie directly on top of each other. Ensure that the Cajun P110
screw holes are aligned with the rack hole positions exactly as shown in figure 3.
Stacking them in this way will allow the switches to be easily connected using the
Exoplane cables.
3.
Secure the switch in the rack using the screws. Use one screw on each side. Do not
overtighten the screws to avoid damaging the plastic.
4.
Connect the Exoplane cables, as described above, and as illustrated in Figure 2.
5.
Snap closed the hinged ends of the front panel.
Figure 3 Cajun P110 rack mounting arrangement