Filter
Top Products
Note: If you don’t see the new drive letter added in My Computer after
driver is loaded properly, the reason could be the hard disk has no par-
tition and format yet, please partition and format the drive in the enclo-
sure before using it.
Hard Drive Partition and Format procedures in PC:
It is recommended to do the partition and format under “USB connection”.
For Windows 98SE
If a new hard disk icon dose not appear in “My Computer”, check device
manager under system in the control panel. Then double click on
“Disk Drives” to see if a new entry appears.
If you can see a new entry as shown (Example, WDC WD80 OBB-32BSA0)
above, you are ready to partition and format the drive.
Please open MS-DOS prompt, run DOS command FDISK to partition the
new hard drive. Then, disconnect and power off PHR-100SU. Turn on PHR-
100SU, reconnect it to computer’s USB port. You will see a new drive icon in
“My computer”. Format it before using the new drive.
16