Filter
Top Products
MAGMA
4 Chapter 2 Hardware Installation
Before you Begin
The power supply is auto-switching. This means that it will automatically
switch to match whatever source power you are using. Since all
products ship with a US Standard 115V power cord, you will need to
use a power cord adapter for non-US Standard 115V power sources.
Install Expansion Interface Card
The first step is to install the PCI Expansion Interface Card.
Four (4) screws retain
the cover on the
expansion chassis.
Remove them to open
the enclosure.
Next, slide the enclosure cover backwards,
disengaging it from the guides at the front of
the enclosure, by firmly grasping the rear cover
lip over the card I/O area and pulling the cover
backward about ½” and then lifting the cover
off.
Finally, install the PCI
Expansion Interface Card
into the PCI Slot marked
Expansion Interface (Slot
J15) and secure it to the
chassis using the
mounting screw
preinstalled above the
slot.