Marantz VP-12S1s Projector User Manual


 
1
ENGLISH
FEATURES
7
Optics
Texas Instruments Digital Light Processing Technology
High Definition Panel (1280 x 720), DMD
TM
HD
16 : 9 Aspect Ratio
Newly developed custom optics by Minolta
1200 : 1 Contrast Ratio
700 ANSI Lumens Brightness
Brightness Uniformity : 90 %
No Halo Effect
Lens Up/Down Shift construction
Short Throw Distance: 80"-8.6ft (2.6m), 100"-10.9ft (3.3m)
Dust Free optics Sealing
No Light Leakage (Double Seals Cabinet Structure)
Extremely Quite (Noise Cancel Duct Construction, Ceiling
Color Wheel Motor)
Long Life Lamp (Average 2000 Hours)
Double Shrink Seal Lamp Structure minimizes Burst Ratio
7
Electronics & Software
Full Digital device
3 Faroudja Chips Inside (Decoder, Doubler, and Enhancer)
3-2 pull down
10-Bit Digital Gamma Processing
Horizontal Keystone Correction
480p, 720p,1080i adapted
IEEE 1394 DV Format adapted for Digital Video Camera
Playback
PC Signal VGA to XGA
Three Picture Modes: Theater, Standard, Dynamic
Nine Picture memories
4 Aspect Modes
Three Color Temperatures
Black Level Selection
Control through RS232C
Two trigger for powered Screen Control
Ecology Lamp mode
DLP, Digital Micromirror Device and DMD are trademarks
of Texas Instruments.
“DCDi” is a trademark of Faroudja, a division of Sage Inc.
“i.LINK” and the “i.LINK” Logo are trademarks.
Even if no trademarks are indicated, they are greatly
valued.
Note: Pixel defects
DMD
TM
(Digital Micromirror Device
TM
) is one of the most
advanced technologies for consumer products. The
DMD
TM
made by high precision technology, however some
pixel defects may be found on the projected image. We
are trying our best to control the quality in order to reduce
the number of defective pixels. It is almost impossible to
have zero pixel defects, even using the most advanced
technology. This is not a problem only for Marantz, but all
DLP
TM
projector manufactures. Therefore we have to note
that the warranty does not cover the DMD
TM
for pixel
defects. We appreciate your understandings.
Note: Lamp
SHP lamp is one of the most advanced technologies for
consumer products. The lamp made by high precision
technology, however some lamps might be failing before it
reaches its life. And projector’s brightness is getting
darker along with accumulated lamp usage hours. We are
trying our best to control the quality in order to reduce
lamp failures. It is almost impossible to have zero failure,
even using the most advanced technology. This is not a
problem only for Marantz, but all projector manufactures.
Therefore we have to note that the warranty does not
cover the SHP lamp for lamp failures: explosion, and non-
lighting except initial use. And also we have to note that
the warranty does not cover the SHP lamp for lamp
failures: flickering, and getting darker along with
accumulated lamp usage hours. We appreciate your
understandings.
INTRODUCTION