Filter
Top Products
Marathon Technologies Corporation 31
On the Endurance Network Setup page make sure that the desired
adapter is still highlighted and select Use currently configured IP
addressing. Click Next to continue.
5. If your network configuration will not use CoServer Link 2, select No
Coserver Link 2 and then click Next without selecting an adapter.
If you will be using CoServer Link 2, then on the Configure CoServer
Link2 page, highlight the adapter you wish to assign as CoServer Link2
in the Connection column. Select the adapter based upon the PCI loca
-
tion-to-switchbay mapping you established during planning and prepara-
tion.
Right click on the selection and choose Internet Protocol Properties
from the action menu. On the Internet Protocol Properties page select
Use the following IP address, fill-in the appropriate address, enter
Subnet mask 255.255.255.0 and click OK.
On the Endurance Network Setup page make sure that the desired
adapter is still highlighted and select Use currently configured IP
addressing. Click Next to continue.
6. If your network will not use a CoServer Management connection, push
Next without highlighting an adapter
If you will be using CoServer Management, then on the Configure CoS-
erver Management page, highlight the adapter you wish to assign for
CoServer Management in the Connection column. Select the adapter
based upon the PCI location-to-switchbay mapping you established dur
-
ing planning and preparation.
If you wish to assign an IP address, right click on the selection and
choose Internet Protocol Properties from the action menu. On the
Internet Protocol Properties page select Use the following IP
address, fill-in the appropriate address, enter the desired Subnet mask
and click OK. Click Next to continue.
7. On the Endurance Network Setup page if the Update Network Con-
nections adapter names box is checked, when you restart the system
Network Setup will reassign the adapter names. Click Apply.
8. Click Exit.