Filter
Top Products
Page 12
INSTALLATION INSTRUCTIONS
1. Shredder is shipped on a metal skid and wrapped with continuous sheets and
stretch film. Remove all strapping and protective covering.
2. The shredder is also shipped with a set of casters bolted to the bottom of the
shredder. However the unit must be lifted out of the skid so that the rollers can
make contact and allow the shredder to be rolled into place.
3. The power cord and replacement bags are shipped inside the bag access door.
4. Roll the shredder into it’s desired location. It should be placed within 5’ of a 20
amp 120 volt electrical receptacle. NOTE! It is recommend that it be placed on a
separate circuit for optimum performance. Do not plug into an electrical circuit that
also powers sensitive electrical equipment such as computer, printer, cash register.
5. Plug the power cord into shredder and then to the desired receptacle.
6. Turn the electrical switch at the rear of the shredder to the on position.
7. Refer to the operator instructions in the operation section of the manual.