Filter
Top Products
ENGLISH
5SW10
TM
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers are set to the same House
Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one TM13 Transceiver or
Marmitek Security Console installed in your house. These components will translate the radio
signals to the Marmitek X-10 signal on the power line. Only one Transceiver should be
installed for all remotes and sensors set to the same House Code.
Am I able to increase the range of my remotes by using more Transceivers?
Yes, you can use more than one TM13 Transceiver in your home when the range of your
remotes is not sufficient. The TM13 is using so called collision detection to prevent signals to
be disturbed when more than one TM13 is transmitting. TM13’s will wait for a quite power
line before transmitting their data. To prevent your Marmitek X-10 System to become slow or
to prevent dimming from becoming less smooth, make sure that the TM13 units are placed as
far away from each other as possible.
USER INSTRUCTIONS SW10 SHUTTER SWITCH
SWITCH OFF APPROPRIATE MAINS FUSE BEFORE INSTALLING!
(INSTALLATION BY A CERTIFIED INSTALLER)
1. Take of the switch cover, remove both screws and take off the mounting plate.
2. Mount the mounting plate onto the flush mounting box with countersunk screws.
Position the plastic décor frame.
3. Connect cables:
Phase to L (_)
Neutral to N
UP to UP
Down to DN
4. When connected, position Shutter Switch on the mounting plate and reinsert both screws.
5. Now program the switch using the following procedure:
PROGRAMMING THE SW10
Now the control electronics has to be calibrated in order to adjust to the time the shutter
motor need from fully closed to fully open:
1. Switch on mains fuse.
2. Use the switch to drive the shutter all the way up.
3. With the aid of a screwdriver, adjust the House Code dial to the * position.
4. Now press the lower push button until the shutter is closed completely.
5. Release the button as soon as the shutter is closed. The electronics measure the elapsed
time and stores it internally so that the switch always knows the position of the shutter.
6. Set the rotary code switches on the front side to the desired address
7. Put the switch cover back on.
The calibration is now completed. The internal electronics have measured and stored the time
for raising and lowering the shutter. These values will not be lost even in case of mains fail-
ure. You are now able to control the switch both by hand and with a Marmitek X-10
Controller (the switch will not respond to Marmitek X-10 signals when the programming has
not been executed).
The switch will respond to the following commands: ON: fully open, OFF: fully closed,
DIM : 4 % up, BRIGHT: 4 % down.
SW10.qxd 02-11-2006 17:20 Pagina 5